V-Star 650

V-Star 650 Bobber Fender Kit

Please note, our fender kit will not work with the stock seat.

Our super heavy duty aluminum fender is 1/8" thick. To top it off we include steel reinforcement straps for all mounting areas. Order either the grey powder coated primer finish or bare aluminum. Sorry but our fender struts will not support a passenger.

$425.00
Add to Cart
  • Available
  • Shipping Time: more than 10 days1
11" or 13” Spring Seat Kit

Please note, our seat kit will not work with the stock rear fender.

$580.00
Add to Cart
  • Limited Availability
  • Shipping Time: more than 10 days1
1929 Ford Rear Light Kit

There are two components to this kit.  First, the rear tail light kit is designed to mount to our side-mount license brackets (vertical or horizontal), and will not mount to stock bikes.  Second, the signal lights mount to the seat brackets.

$235.00
Add to Cart
  • Limited Availability
  • Shipping Time: more than 10 days1
License/Tail Light Brackets

Yamaha V-Star 650 license plate bracket. Choose between vertical or horizontal mount.

$100.00
Add to Cart
  • Limited Availability
  • Shipping Time: more than 10 days1
Front Fender Kit for Classic Model Only
$267.00
Add to Cart
  • Limited Availability
  • Shipping Time: more than 10 days1
Front Light Kit to Match 1929 Ford Light

This kit includes gloss black, powder coated mounting brackets and a pair of awesome mini aluminum signal lights, (available in polished aluminum or black).  They match our '1929 Ford Rear Light Kit'.

$130.00
Add to Cart
  • Limited Availability
  • Shipping Time: more than 10 days1
1" Drag Bar Kit - 32"

Be sure to look at the pictures of throttle cable location.  If your throttle cables exit ABOVE the brake lever then this 32" drag bar will work just fine.  If they exit BELOW the brake lever you will have to use our 36" bar with the spacers.

$125.00
Add to Cart
  • Sold Out
Drag Bar Spacers

These billet aluminum spacers are machined to raise your bars 2".  That allows the drag bars enough room so the switch housing won't hit the tank when turned all the way.  Our DVD shows easy install.  It only takes a few minutes to install these spacers!

$80.00
Add to Cart
  • Sold Out
Exhaust Wrap Kit

Exhaust wrap kit, 2" wide x 25 ft. long roll. One roll does approximately 4 ft of pipe with 1/4" to 1/2" over-lap on a 2" diameter exhaust. Includes 10 stainless steel wire ties. (Enough for one bike). Instructions included.

Please choose the color you would like.

$30.00
Add to Cart
  • Available
  • Shipping Time: more than 10 days1

Bobber Parts Kit